Dresden 2011 – wissenschaftliches Programm

Bereiche | Tage | Auswahl | Suche | Aktualisierungen | Downloads | Hilfe

CPP: Fachverband Chemische Physik und Polymerphysik

CPP 12: Organic Semiconductors II: Solar Cells B (jointly with HL, DS)

CPP 12.4: Vortrag

Dienstag, 15. März 2011, 11:30–11:45, ZEU 222

Quantitative analysis of optical spectra and solar cell performance of P3HT:PCBM blends — •Sarah T. Turner, Patrick Pingel, Robert Steyrleuthner, and Dieter Neher — Institute of Physics and Astronomy, University of Potsdam, Germany

The properties of solar cells made from a blend of regioregular poly(3-hexylthiophene) (P3HT) with [6,6]-phenyl-C₆₁-butyric acid methyl ester (PCBM) are known to depend largely on the layer morphology. Here, we present the results of optical studies on P3HT:PCBM blends coated from chloroform and dichlorobenzene with subsequent thermal annealing. A recently established analytical model developed by Spano for the absorption of weakly interacting H-aggregates was used to obtain information about the fraction of crystallized chains, the width of the aggregates, and the energetic disorder in the P3HT phase ^[1]. In terms of an increased aggregate width and a decreased energetic disorder in the P3HT phase, thermal annealing was found to have little effect on the films prepared from dichlorobenzene and an appreciable effect on the films prepared from chloroform. The results from the model were compared with the performance of solar cell devices and single-carrier devices with the same active layer. Most importantly, the initial increase in P3HT aggregate size upon thermal annealing showed a good correlation with an increase in hole mobility. Further increases in solar cell device performance at higher annealing temperatures were correlated with a decrease in P3HT energetic disorder and an increase in PCBM aggregation.

[1] F.C. Spano, J. Chem. Phys. 2005, 122, 234701.